Transcat Two Way Transparent Pet Door Flap for Dogs

The Transcat Dog Door has a 4 way locking system that allows for locking the door in either direction, both directions or not at all. It allows for easy control by the owner from both the inside & outside. Your dog can come and go without you having to stop what you are doing!.

Size : (Outside frame) - 40 cm (diameter)
(Inside frame) - 28.50cm (width) x 25cm (height)
(See Picture of measurement)

Installation into Single Pane Glass

1. A circular hole is simply cut by a competent glazier and your Transcat Dog door fitted in the following manner:
The glazier should be consulted about where to cut the hole but owners should also consider factors such as the height of the dog's legs and whether or not they are fully grown. The dog should also be able to go through the dog door without having to jump up or crouch down.

2. The hole in the glass should be 385mm in diameter.

3. The two main parts of the Cat Door are then clamped with the glass between. Use the four bolts supplied. IMPORTANT! Assemble the door so that the frame with the flap is on the outside.

4. Nuts should be fitted finger tight only, to prevent unnecessary stress being place on the glass. This is sufficient to hold the door.

Installation into a Double Glazed Panel of Glass

1. A circular hole is simply cut by a competent glazier and your Transcat Dog door fitted in the following manner:
The glazier should be consulted about where to cut the hole but owners should also consider factors such as the height of the dog's legs and whether or not they are fully grown. The dog should also be able to go through the dog door without having to jump up or crouch down.

2. The hole in the glass should be 385mm in diameter. The hole should be sealed by the glazier to maintain the integrity of the double glazing.

3. The two main parts of the Dog Door are then clamped with the glass between. Use the four bolts supplied. Longer bolts are available in lengths of 30, 35 and 40mm. IMPORTANT! Assemble the door so that the frame with the flap is on the outside.

4. Nuts should be fitted finger tight only, to prevent unnecessary stress being place on the glass. This is sufficient to hold the door.

The door is made from tough polycarbonate plastic but will break if put under strain for which it is not intended. Care should be taken not to allow a sliding door to hit the side of the flap which might still be swinging because if it is hit from the side it will break.

Filters

transcat

Transcat Two Way Transparent Pet Door Flap for Dogs